News from the Tennessee Valley State, Local and National news
FRIDAY, JANUARY 27, 2006
HOME | NEWS | FORUMS | ARCHIVES | OBITUARIES | WEATHER

Cut utility bills by replacing old furnace

Dear Jim: With gas prices so high now, I think I should replace my old furnace even though it still works. I want the most efficient design to save money and reduce pollution. What models should I consider? Pete J.

Dear Pete: With today's high energy prices, it probably does make good economic sense to consider replacing your old gas furnace. Depending upon how inefficient it is, installing the highest efficiency design will cut your gas bills by as much as 40 percent and lower your electric bills.

The most efficient new gas (all can be easily converted to propane) furnaces have AFUEs (efficiency ratings) as high as 96 percent. This means only 4 percent of the heat from the gas is lost out the flue. Your old furnace can lose more than 40 percent of the heat content of the gas up the chimney.

When a furnace is operating properly, burning of gas or propane produces little air pollution. The main concern is the carbon dioxide, which may cause global warming and climate change. Because a new high-efficiency model burns 40 percent less gas, it will produce 40 percent less carbon dioxide.

The most efficient gas furnace design uses a special gas valve which can control the amount of heat produced. Some are two-stage designs with a low- and a high-output burn rate. Others use a modulating gas valve which can vary the output in several percentage increments.

The advantage of these types of furnaces is they vary the amount of heat produced depending on the instantaneous heating requirement of your house. During mild weather when your house loses less heat through the walls and ceiling, the furnace runs at the low-output level. When it gets very cold outdoors and more heat is needed, it automatically switches to high-output.

By matching the furnace heat output to the changing heating needs of your house, the furnace runs longer with few on/off cycles. Just as your car operates more efficiently using less gasoline on the highway than in stop-and-go traffic, so does your gas furnace when it runs in longer cycles.

To realize the most utility bills savings and comfort, select a new furnace with a variable-speed ECM (electrically commutated motor) blower motor. When the furnace is running in low-output mode, the blower motor runs slower so the air blowing out of the registers still feels hot. These motors are quiet and have soft start so you may not even hear them start.

It would be wise to install a matching thermostat from the furnace manufacturer to take full advantage of all its efficiency and comfort features. The newest thermostats give you control over temperatures, humidity, and blower speeds.

Write for Update Bulletin No. 761, a buyer's guide of the 19 most efficient modulating and two-stage gas/propane furnaces listing AFUEs, capacities, blower motor types, warranties, and sizing and savings charts. Please include $3 and a business-sized, self-addressed, stamped envelope to: James Dulley, THE DECATUR DAILY, 6906 Royalgreen Drive, Cincinnati, OH 45244.

Dear Jim: When we go to work in the morning, my husband leaves the television on for our dog. He says it is better for the television to leave it on because the tubes will last longer. Is this true? Carolyn F.

Dear Carolyn: This is not correct and it is wasting electricity. Although new solid state televisions use less electricity than old tube-type ones, they still use a substantial amount of electricity if they are on all day long.

If your dog is really addicted to CNN or Fox News for company, purchase a tiny black and white television for him. These use less electricity than color ones and your dog will still be able to get the hourly stock quotes.

Subscribe for only 33¢ a day!

Leave feedback
on this or
another
story.

Email This Page


  www.decaturdaily.com